ExoWrap^® Insulation System

	ExoWrap®, the ‘one-step’ insulation system, is the quick and easy way to insulate high temperature surfaces in vessel engine rooms. ExoWrap® is a revolutionary system made from biosoluble vitreous silicate fibre which is reinforced with an outer jacket of heat sealed aluminum foil. In tape or blanket format, ExoWrap® is applied in one step eliminating the need for bulky and time consuming layered insulation. ExoWrap® can be easily removed and reinstalled by using the ExoWrap® ‘Silhesive’ Tape and is rated for use to 1,000º C max. ExoWrap® can be used throughout the engine room.
Meets IMO Resolution MSC.61(67) Adoption of the international code for application of fire test procedures. Each ExoWrap® Blanket Roll is supplied with one roll of ExoWrap® ‘Silhesive’ Tape for fastening. Meets SOLAS Regulation ll - 2/15.2.10 “Surfaces with temperatures above 220º C which may be impinged as a result of a fuel system failure shall be properly insulated.”	ExoWrap® Tape For use on bent and flanged pipes in areas where maintenance is not a consideration and/or space is limited. ExoWrap® has a pressure sensitive adhesive on the inner side for ease of installation. Application Instructions 1.) Remove dirt, oil, scale and excessive moisture from surface.   2.) ExoWrap® is wound around the pipe in a spiral motion using a 50% overlap to ensure good adhesion. Be sure that the foil edges are securely fastened. Ends can be secured with wire or clips if desired.
	ExoWrap® Blankets For use on straight pipes, valves, exhaust equipment, turbochargers, angled and uneven surfaces and anywhere that insulation is required. ExoWrap® Blankets are secured with ExoWrap® ‘Silhesive’ Tape for ease of maintenance. Application Instructions 1.) Cut the ExoWrap® Blankets to size with a utility knife or shears. Wrap around the surface to be insulated, butting the ends together forming a seam.   2.) Secure and seal the seam with Silhesive Tape.   3.) To remove ExoWrap® Blanket, cut the Silhesive Tape and unwrap from metal surface. To reinstall, new Silhesive Tape must be applied.