Trusted Protection For The Marine Industry
NoSpray® Protective Tape
NoSpray Protection SystemNoSpray Protection SystemNoSpray Protection SystemNoSpray Protection System
NoSpray® Protection System is a type approved aluminum/glass cloth jacketing system designed to prevent the flammable spray of hot oil which can come in contact with hot surfaces thus causing fires in vessel engine rooms. NoSpray® is available in tape or sheet format and is coated on one side with a silicone adhesive for ease of installation and superior adhesion.
Meets SOLAS
Regulation II - 2/15.2.11		 ABSVeritasClassNKCCSDNVLloyd's RegisterRINA
NoSpray Protective Tape product specifications chartNoSpray Protective Tape product specifications chart

Applications
– Fuel oil injection pipes, fuel oil service
   pipes, fuel oil valve cooling oil pipes
   attached to diesel engines

– Lube oil service pipes and hydraulic
   oil pipes attached to diesel engines

– Flammable oil pipes

– Flammable oil pump and strainer

– Fuel oil heater

– Lube oil heater and cooler

– Fuel oil purifier - Lube oil purifier

– Fuel oil burning unit for boiler, thermal
   oil heater, inert gas generator and
   incinerator

– Level gauge, fittings and oil tray of
   flammable oil tank

 
The preceding areas of fire risk should be protected from the following sources of ignition:

– exhaust gas pipe

– steam pipe

– turbo charger

– electrical equipment

– boiler, thermal oil heater, incinerator

– welding spatter, cigarettes, etc.

 
For Protection of Insulated High Temperature Surfaces

NoSpray can be used as a protective shield on insulated hot surfaces which are in close proximity to potential oil spray in the engine room.

NoSpray Protective Tape product cross section
NoSpray Protection System
NoSpray Protection System assembly cutawaysNoSpray Protection System assembly cutaways
Application Instructions
1.) Be sure that all surfaces to be protected are cleaned and free of oil.
 
2.) Select the NoSpray format applicable to your installation, and, with adhesive film in place, cut with scissors as follows:
 
For Pipes and Joints
Use NoSpray Tape and allow overlap of 50% each turn.
 
For Valves, Flanges, and other irregular shaped equipment
Use NoSpray Sheet and cut one piece:
 
– Length to wrap 2 layers thick around surface to be protected.
– Width to be enough to completely cover bolts and overlap onto connecting
   pipe at least 100 mm (4”).
– Special care must be taken where a device such as a valve is connected
   to the pipe being wrapped. In this case, the NoSpray Tape must be
   wrapped around the attached device as well as the pipe.
– When using NoSpray Sheet, apply NoSpray Tape on top of the sheet
   overlapping 50% to secure the NoSpray Sheet.
 
3.) Important Tip
When applying NoSpray Tape, be sure to wrap loosely to allow free flow of oil leak. DO NOT WRAP TIGHTLY.
 
4.) When applying NoSpray Sheet or Tape, peel off the adhesive film a little at a time so as not to contaminate adhesive surface with dust or oil prior to application. Wrap snugly (not too tight) around pipe or joint in the likely direction of an oil spray leak. NoSpray Sheet or Tape should be continued to a point where any potential leaks would occur safely away from hot surfaces that could cause combustion.
 
5.) For maintenance and repairs, NoSpray can be removed by cutting with a knife, or tearing with pliers. NoSpray cannot be reused once removed.
 
6.) Important Note
Periodic inspections must be carried out in areas applied with NoSpray Tape. Unravelling, curling, loosening or cracking indicates tape on the applied area must be replaced.