Trusted Protection For The Marine Industry
NoSpray® Shields
NoSpray Shields contain the spray of hazardous liquids NoSpray® Shields are designed to contain the spray of hazardous liquids in vessel engine rooms, a cause of dangerous fires and loss of life and property.

NoSpray® Shields are manufactured in multiple layers from a silicone rubber applied on a silica fibre fabric, specially formulated to withstand high temperatures and pressures, and an aluminum foil lining, which creates a corrosion resistant barrier for long lasting protection.

NoSpray® Shields are available in various widths which can be cut to size for use on flanges, valves, fittings, or any irregular shaped surface which can leak hazardous liquids. NoSpray® Shields encapsulate the protected surface and are easily installed using our drawstring system. Removable, reusable and extremely durable, NoSpray® Shields provide a consistent, clean look in vessel engine rooms.
 

NoSpray Shields product specifications chart
4“ Roll for typical flanges on a 25 mm (0.5”) to 50 mm (1”) pipe diameter
6” Roll for typical flanges on a 50 mm (1”) to 100 mm (2”) pipe diameter
12” Roll for typical flanges on a 100mm (2”) pipe diameter and up


Meets SOLAS
Regulation II - 2/15.2.11
Installation Instructions NoSpray Shields assembly cutaway
1.) Measure the outside diameter of the flange and cut the NoSpray Shield to a length of 130%.
 
2.) Cut a small hole about 1” (25mm) from each end of the shield on the pocket.
 
3.) Centre the shield on the flange and wrap snugly, overlapping the ends.
 
4.) Thread a lacing wire through each of the two cut holes and pull the lacing wire through the pockets.
 
5.) Draw together and fold under the cut edge of Shield for a neat finish.
 
6.) When pulled together snugly, secure with pliers and cut off excess wire.